Sanus Systems TV Mount VM3 User Guide

Assembly Instructions for VisionMount LCD Wall Mount Model: VM3  
Thank you for choosing Sanus Systems Vision Mount furniture. This product is  
designed to mount VESA 75/100 compatible LCD televisions up to 30 pounds  
onto a vertical wall. It allows you to effortlessly tilt and swivel your new televi-  
sion up to 15° in either direction as well as extend it up to 12” away from the wall  
without the use of tools. Check carefully to make sure there are no missing or de-  
fective parts. Never use defective parts. Improper installation may cause damage  
or serious injury. If you do not understand these directions, or have any doubts  
about the safety of the installation, please call a qualified contractor or contact  
stallation questions and missing or damaged parts. Replacement parts for Sanus  
products purchased through authorized dealers will be shipped directly to you.  
Required Tools: Drill with 3/16” bit, Phillips screw driver  
(2) Wall Mount Screws - a  
(1) Allen Key - b  
(4) M4 Bolt - e  
(4) M5 Bolt - f  
(4) Knob Replacement  
Bolt - g  
(1) Monitor Mount - d  
(1) Large Washer - h  
(1) Cap - i  
(1) Small Washer - j  
(1) Knob - k  
1] Attaching to the Television: Attach the Monitor Mount (d) to the back of your LCD television using the proper bolts as shown in Diagram 1. Place 4 bolts through the  
Monitor Mount and tighten snugly into the VESA bolt mounting pattern on the back of the television. Make sure the large side of the tapered hole on the Monitor Mount faces  
toward the bottom of the television. M4 (e) and M5 (f) bolts are provided. Other sizes are available at your local hardware store.  
2] Attaching to the Wall: Hardware for wood stud mounting is provided. For all other mounting applications contact a specialist. Use a high quality stud sensor to locate a  
stud. It is a good idea to verify the stud location with an awl or thin nail as shown in Diagram 2A. Use the Wall Plate as a template to mark the two hole locations on the wall.  
Make sure these holes are aligned vertically and centered over the stud. Pre-drill the two holes using a 3/16” drill bit. Attach the Wall Plate to the wall using the two Wall Mount  
Screws (a) as shown in Diagram 2B. Tighten the Wall Mount Screws with the Allen Key (b) until they are snug.  
Sanus Systems 2221 Hwy 36 West. St. Paul, MN 55113  
 

Radio Shack Radio 120 0738 40 User Guide
RCA Camcorder JOYTECHTM AV CONTROL CENTER 2 User Guide
RCA DVR AVC 776 User Guide
Roland Electronic Keyboard RM 700 User Guide
Rolls Stereo Amplifier MA2152 User Guide
Samsung CRT Television WS28V53NS8XXEC User Guide
Samsung Printer SRP350II User Guide
Sanyo Flat Panel Television LCD 19E3 User Guide
Sanyo Telephone CLT OHE40 User Guide
Sears Saw 43783163 User Guide